Concrete for a 8 x 8 ft Slab
Everything for a 8 x 8 ft slab (64 sq ft) — shed base or grill pad: cubic yards at 4, 5 and 6 inches thick, bag counts, base gravel, rebar and cost.
Quick answer
Disclosure: CementCalc is free to use and supported by ads and affiliate links. As an Amazon Associate we earn from qualifying purchases. Full disclosure.
Volume at each thickness
| Thickness | Cubic feet | Cubic yards | Order (ready-mix) | 80 lb bags | 60 lb bags | Weight |
|---|---|---|---|---|---|---|
| 4 in | 21.3 | 0.79 | 1 yd³ | 40 | 53 | 1.76 tons |
| 5 in | 26.7 | 0.99 | 1.25 yd³ | 49 | 66 | 2.2 tons |
| 6 in | 32 | 1.19 | 1.5 yd³ | 59 | 79 | 2.64 tons |
volume = 8 ft x 8 ft x thickness/12 | yd³ = ft³ / 27
At 4 in thick
Concrete to order
1yd³
0.79 yd³ before waste
80 lb bags
40
Base gravel (4 in)
1.58tons
Compacted crushed stone
#4 rebar at 16 in
5sticks
60 lb, or 2 mesh sheets
Concrete cost
$165
At $165/yd³, before delivery
Pouring a 8 x 8 ft slab
At 64 square feet this pour needs 1 yards, which is under most plants' truck minimum — expect a short-load fee, and compare against bagged mix before ordering. Excavate for 4 inches of compacted base plus the slab thickness, and set forms to a slope of about 1/8 inch per foot away from any structure.
Control joints go in at one quarter of the slab depth, spaced no more than two to three times the thickness in inches converted to feet — for a 4 inch slab that is roughly every 10 feet. Keep the surface moist for seven days.
Source & method: Volumes are geometry (8 x 8 x thickness), bag counts use published nominal yields, weight uses 150 lb/ft³, and the gravel figure uses 135 lb/ft³ for compacted road base. Cost uses a $165/yd³ default — adjust it on the slab cost calculator.
Supplies for this slab
Links below are affiliate links. If you buy through them we may earn a commission at no extra cost to you.
- Form stakes (24 in steel)4 in slabHold form boards to line and grade against the pressure of wet mix.Check price
- Expansion joint stripIsolate the slab from footings, walls and adjoining concrete.Check price
- Vapor barrier (6 mil poly)Required under interior slabs and worth it under any garage floor.Check price
- Concrete cure and sealHolds moisture in for the first week so the slab reaches strength.Check price
Frequently asked questions
- How much does a 8 x 8 ft concrete slab cost?
- Concrete alone is about $165 at $165 per cubic yard, plus roughly $120 delivery. Add base gravel and reinforcement for materials near $400, or $656 installed with labor at $4 per square foot.
- How thick should a 8 x 8 ft slab be?
- 4 inches for foot traffic — patios, shed floors and walkways. Step up to 5 or 6 inches where a vehicle will park or where you will store heavy equipment. Shed base or grill pad is the typical use for this size.
- How much rebar does a 8 x 8 ft slab need?
- About 5 twenty-foot sticks of #4 bar for a 16 inch grid both ways — 90 linear feet weighing 60 lb. Welded wire mesh is the cheaper alternative at about 2 sheets.
Related calculators & charts
- Concrete CalculatorCubic yards, bags and weight for slabs, footings, columns, steps and curbs.
- Concrete Slab Cost CalculatorReady-mix versus bagged cost for a slab, including delivery and short-load fees.
- Concrete Bag CalculatorHow many 40, 50, 60 or 80 lb bags a pour needs, by published bag yield.
- Post Hole Concrete CalculatorConcrete per hole and per fence run, with the post volume subtracted.
- Cubic Yard CalculatorConvert any length, width and depth into cubic yards, feet and tons.
- Gravel CalculatorTons and cubic yards of gravel, crushed stone or road base for any area.